This printer is limited to a 200mm cube and so I want to chase precision. Making small things accurately. And the only parts I think I am going to add here are a SKR 1.4 Turbo mainboard and 4 or 5 LV8729 stepper drivers all run at 1/128 micro stepping. Past that I want to move all wires to the backside of the frame and design and print some pieces to reinforce or brace the smooth rods. So far I have this piece designed that I will print and mirror and print and install under the Z stepper motors to add support to the threaded rods under the smooth rods for Y. This will keep the top of the frame from flexing forward or the front of Y from shifting to either side. I have designed this part to be a tight fit on the threaded rods..