Results 1 to 1 of 1
Thread: 3D Printer Enclosure
-
12-22-2019, 01:29 PM #1
- Join Date
- Dec 2019
- Posts
- 1
3D Printer Enclosure
Hey all
These days I tried to print a gear knob for the car and after 3cm I had the wraping problem. It printed another 2-3cm well and then again.Reading on the internet I came to the conclusion that it was because it had cooled very quickly. I had a few rectangular aluminum tubes I began to make the box. I also used two Ikea tables hahaha (they have the perfect dimensions) to make it a little higher and store things below. I bought a 5m led strip to light it. The isolation was given to me by a friend.
This is how it looks
03.jpg
02.jpg
01.jpg
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials