Anet A8 Sudden print quality issue

[freddygitar]

Hi again,Finaly I think I have resolved the problem.-I have updated the Cura to 4.4.1 ( I don't think that this was the problem)-I have observed that I didn't set up a material profile. So I set up the profile regarding to the PLA I use ( Gembird and it has the mat. specification : density etc)-And last I have raised the hotend temp. It was 200 celsius, I have raised it to 210 ( I have read somewhere that the tempcontrol read less celsius than realy is)So as you can see on Pic attached now the print is smooth (I think )
When I have time I try another litophane and come back wiht a result .