Looks good Freddy. Glad you figured it out.

I may have resolved my issue too. 2 days ago, I loosened my y axis belt enough to slip it off the stepper motor and moved my print bed back and forth....was not smooth at all and kind of difficult. I was really surprised since I know it was smooth and easy after I replace the bearings. I set to correcting this issue when I discovered many of the screws holding the caster thingies (not sure what they are actually called) were loose. I must not have tightened them enough. with them being loose there is just the tiniest amount of play. I think a combination of a belt that wasn't quite tight enough and the little bit of play from loose screws was causing my issue. This may also explain why my problem was primarily on the right hand side, where their were more/looser screws. And also why tightening the belt reduced but didn't entirely eliminate the issue. My print from yesterday turned out well...here's to hoping we didn't miss anything else.