Flashforge Creator Pro printing setup issue

[Miho Mihov]

Capture.JPGHi curious-aardvark,

Hi, My name is Miho Mihov, bridge engineer, live and work in Australia, new to 3D printing. Just joined this forum, hoping to learn more about 3D printing. Bought recently a FlashForge IDEX 3D printer Creator 3. I have questions about the slicing software FlashPrint. How do I post a new thread if I cannot find an answer within the forum? In the meantime, I find that FlashPrint slicer creates tree type supports which do not appear to be the most structurally efficient - often inclined straight from the base and forming a zig zag alignment even before the first branching off.

Is there a way to control this or is it normal and would not cause problems printing?

Thank you in advance.

Miho Mihov