Close



Results 1 to 3 of 3
  1. #1

    slicing in 2 parts for support material and the project it self?

    Hello!Is there any setting in Cura That allow printing in 2 parts? So I could use for example PVA for support material and to print my project out of TPU?

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    7,159
    supports usually have their own set of settings anyway.
    Even cura should do that. plus if you're using a dual extruder - then the second extruder will also have it's own settings. Just tell it to use the second extruder for supports.

    You can't print support then print a print with a single extruder printer. as the print head would knock the support out of the way.

  3. #3
    Well yes wanted to know if it's possible to do it somehow with a single extruder. I'm planning to use TPU but will try my best to get it clean. But thank you

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •