Results 1 to 6 of 6
Thread: Anet A8 auto Home not working
Threaded View
-
11-24-2019, 02:52 PM #2
When flashing new firmware you need to send code to read the firmware and store the firmware configuration into memory.
To do this send
M502 - Factory Reset
// If you need a different Z-Offset you can enter it here
// M851 - XYZ Probe Offset
M500 - Save Settings
I do this from Cura 15.04.6 in terminal mode
This can also be done from LCD
Load Settings
// If you need a different Z-Offset you can enter it here
// M851 - XYZ Probe Offset
Store SettingsLast edited by Roberts_Clif; 11-24-2019 at 02:59 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion