Subscribe to Our Newsletter Advertise
Close



Results 1 to 8 of 8

Threaded View

  1. 10-31-2019, 08:15 AM #3
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    You could also uses a hair dryer, it should get to a high enough temp to carefully remove the PLA.
    If your temp reading is zero degrees C then you may have a dead thermister or unplugged thermister.
    Last edited by Roberts_Clif; 10-31-2019 at 05:46 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules