Quote Originally Posted by roykirk View Post
While I've heard it can be done, I'm not printing directly on the glass, instead continuing to use blue painters tape. My main reason being that sometimes my models really stick hard to the platform and I have to use a putty knife to "pop" them off. I didn't want to scratch the bejeesus out of the glass plate right off the bat. Perhaps I'll give it a try without tape at some point.
I think you are worrying too much about the glass. It doesn't scratch that easily and it is very cheap to replace (at least if you use thin picture frame glass). What I do is wedge a single edged razor blade under a corner of the print. And then I wedge a small flat bladed screw driver under the razor blade as close as possible to the print. Usually, with a little bit of a twist to the screw driver, it pops off the glass.