So what you showed is normal yes? And only way around it is to either print at lower layer heights, print slow (not sure but that and increased nozel temp on first layer looked better for me which I only did to get better adhesion), using something like ironing in cuda, or post processing is the suggested ways to reduce? I found that increasing temperature for me caused rough, almost hairy/rough in spots in places for the St-pla from creality I'm using..

I really should play around with various test prints rather than real life prints huh? So I can experiment with various settings on prints that don't take long to print. I jumped straight into real prints so maybe I should take one step back.