They also sell 12/24V versions but if it's not too difficult 120V would heat faster. To use a 120V heater, how do i set up the temperature controls?
I know this one !
lol
You use a mosfet. basically mains is connected directly to the mosfet, that is then connected to the correct connectors on the motherboard. So the controls go thorugh the usual places on the board, but the power comes direct from the mains.
this type of thing: https://www.ebay.co.uk/itm/3D-Printe...item59348496c0
Also lets you run a 24v bed through mains, so you don't overload the motherboard.