So I figure out it was the X axis bar when assembled stright was actually curving down a few mm (where I was getting the nozzle being closer on one side than the other even when all 4 corners where tightened down all the way). So I loosened the 2 screws that bolt the bar to the axis trigger piece that slides down the z axis frame and pushed it up as far as it would let me before re-tightening the bolts which only put it about a half mm off, but I can fix with bed level adjustment. I do like the stiffer springs though, takes more effort to adjust the level and feels like it wont unadjust itself as easily as the original springs. I plan to get a Prusa eventually, but I wanted something to prototype with while my main printer was doing the quality prints