Best filament for durability as bushings

[airscapes]

Ah, maybe I figured I would never need that last time I bought nozzles and never stored that data in my brain.. or I am just getting old.. I will have to buy another hotend and the .75.. I change the hot ends rather than nozzle.. faster and less tools.. :-)

You may want to lower your temp.. I use Esun and MakerGrear abs and always print at 235 with very few issues. Do a Pid calibration on your hoted if you have never done one
On the terminal with the hot end cold and off send M303 wait till done. wire down the ouptut as the printer may disconnect do to time out during the test as it takes a few minutes. Reconnect if need be and Enter the values last reported which you wrote down like below (your numbers will be different) Then send a 500 to save.

When I switch nozzles I switch hot ends. I have run Pid cal on each hot end and saved the values in a spread sheet. When I change a nozzle size and hotend set my starting height and set the Pid for the particular hotend I have installed

.25 M301 P17.49 I1.16 D65.95
.35 M301 P19.97 I1.39 D71.56
0.5 M301 P18.64 I1.24 D71.83