Best filament for durability as bushings

[petersglassshop]

Interesting...but if I check with a feeler gauge...the nozzle measures about 0.3mm from the printing surface...how can I lower it by 0.6mm?

And, with the PEI sheet applied...my adhesion problems seem to have been fixed completely!

[airscapes]

Interesting...but if I check with a feeler gauge...the nozzle measures about 0.3mm from the printing surface...how can I lower it by 0.6mm?

And, with the PEI sheet applied...my adhesion problems seem to have been fixed completely!

Guess if that is the case no need to mess with it further but when you have time it is worth while to get familiar with the process of altering the offset at the firmware level. I believe you can make changes in Simplifed 3d but not sure if you need positive or negitive numbers. That is also for that one print only and not universal like in the firmware

[petersglassshop]

OK, both machines back in their proper location (out in the heat)...we'll see how things go. So far so good with PEI!

1010191406.jpg