Best filament for durability as bushings

[airscapes]

So, so since I do not usually have the machines connected to a computer, then how do I program my jobs with the adjustment so that they all run with the offset?

You make the adjustment in the EEPROM using the M206 as explained in the previous post. Once that is saved with M500 it stays that way until you change it.

If you adjust it using the Z offset in S3d you need to do it on every single model and replace your Gcode, which is probably not want you want.

If the PEI is working and your stuff is not falling off, don't mess with success :-)

I guess I need to get some PEI to try..