ABS warping and extrusion issues

[Roberts_Clif]

I created a single sheet plywood case for dual 3D Printers, I read that this is the easiest way to keep ABS from warping.

I print with a bed temp of 96C and a hot-end temp of 236C.
I start printing at 32-50%
I then increase the Speed to 72-86%
I print on Paper Tape and a Chinese Build surface.
I print with 20-46 % Infill
and a layer Height of 0.2-0.31mm

In fact I have printed with the fan on up to 121 about 50% fan speed, would not recommend using the fan though without a heated case.

Sample ABS Prints This assembly requires 63D Printed Pieces.

C-Foot.jpg

Middle Assembly.jpg


Enclosure

The Twins 2018.jpg


I post this because your number are so close to mine that all you need is an enclosure. An more 3D Printing experience.