Ender 3 Pro print problem...

[SASH]

increase the length nd speed of retraction.
You've got a bowden extruder, so the retraction length needs to be fairly long to make any real difference.

When you say length and speed of the retraction.... do you mean then minimum travel? Option #1 in the menu?
Capture6.jpg

[SASH]

There's no real disadvantage, as far as I can determine, to increase the z-hop to clear your streaks. Make lifts in 0.200 increments for 0.200 layer height and you should be clear.

I set the Zhop to 0.200 and the minimum travel to .5. i dont think the streaks are as thick.
20190729_020445.jpg