First print ever...what happened here?

[Roberts_Clif]

What slicer are you using? I would really like to see all slicer settings. Though taking my best guess.

It appears that you are printing too hot and burning the filament reduce the Hot-end temp to 202C.
It appears that your bed adhesion is not working Clean your bed with 70% Isopropyl alcohol or higher.
Increase the print speed to 40% for the first layer then increase the speed to 60% for remaining print.
If you do not have a parts fan get on set it to about 50% after the first layer is printed.

As this is your first print I would also change your layer height to .24 this layer height is fine for a Raspberry Pi Case.