Results 1 to 10 of 12
Hybrid View
-
07-22-2019, 08:08 AM #1
I would start by checking out the beds eccentric nuts, if the eccentric are nuts are not at the right tension the bed will wobble, which will cause layer adhesion problems.
I would make sure that the Bed leveling adjusters springs are about 1/2 compressed, if they are too loose this could also cause the wobbling effect.
-
07-22-2019, 12:52 PM #2
-
07-22-2019, 02:55 PM #3
- Join Date
- Jul 2019
- Posts
- 10
-
07-22-2019, 05:31 PM #4
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion