Results 1 to 5 of 5
Hybrid View
-
10-05-2019, 12:26 AM #1
- Join Date
- Oct 2018
- Posts
- 8
Update on this.
I solved it by running though a complete calibration and following the flowrate and stepover sample tests.
Essentially the flow rate needed re calibrating and the stepover was too high. I think the original extruder was worn out but the settings had been tuned to suit. When I changed to a new extruder and nozzle I had to change it.
I learnt a lot and the final prints are the best ive ever had now! Have run over 80lb of material with no failures!
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials