Results 1 to 4 of 4
Threaded View
-
07-09-2019, 02:50 AM #1
- Join Date
- Jul 2019
- Posts
- 6
Can't increase retraction rate with Cura on Lulzbot Taz 6
I'm experimenting around and I was recommended to use Cura to slice my models. I was messing around with it and was having some stringing, so I started to try messing with the retraction distance and speed. I very quickly realized that for some reason the speed is capped at 40mm/s. I'm not sure if that's a printer physical limit, or if Cura is just being weird. I tried adjusting settings that might affect the retraction speed setting and hoped for some miracle fix, with no avail.
Any ideas why this might be happening?
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help