Please help!

[Xion]

It could help to tell us what your Slicer settings you are using along with which slicer, Example Bed temp, Nozzle Temp, Print Speed, Layer height ect...

Right, sorry. I'm still new to this.
PLA
Machine: Ended 3 with upgraded firmware
Slicer: Cura
Nozzle: 215
Bed: 65
Speed: 60
Layer: 0.15
Infill: 80%
8 shell layers.
Glass bed

Am I missing anything important?

[Roberts_Clif]

I would make a couple of changes as a beginner.
When I started I could not print on a print surface to save my life, though I could print in a tape.
What I am suggesting is to try a print on Blue Painters tape, then later when you gain experience return to the Glass bed.

Reduce the temp 5C on the nozzle and reduce the temp 10C on the Bed.
Printing at a thinner layer height is a experienced art, as a beginner start at a layer height of 0.2mm
Change your infill to 30 -50% an your shell to 4, and set the parts cooling fan to about half speed.