Ender 3 Pro with wall/shell issue

[Hemi345]

No, it doesn't show up in preview. The stringing was pretty bad with PrusaSlicer even though my retraction settings were the 'same' as what I've dialed in on Cura, so I think I'll just stick with Cura. I adjusted some acceleration settings last night and tried again, but printed it full size this time. The results are much better, but still just a tad off. I'm almost satisfied with the results now, but anything to dial it in more would be awesome. Attached is another pic and the stl for the temp tower I'm printing. I edited one of Thingiverse to make it only two levels and fix the bridge (it wasn't connected on one end!).