after end print, my CR10S-pro goes to Z-0 WHY?

[Rich3d]

I would start by removing the G28, I know it is only supposed to home the X axis, but I dont think you the "X0". I beleive you only need the "G28 X".

Not sure why you want to re-home just the X Axis you could just do a G0 X0, that will move X to the 0 position without running the home routine.

[rasmusdc]

I would start by removing the G28, I know it is only supposed to home the X axis, but I dont think you the "X0". I beleive you only need the "G28 X".

Not sure why you want to re-home just the X Axis you could just do a G0 X0, that will move X to the 0 position without running the home routine.

i don?t really want it to do anything, i?m fine with it just stopping and turning off all the elements..

this is just simplify 3d?s way of ending the print.... i?m just trying to locate.. WHY it began doing this..

might try my laptop, since it has my old CR10S-Pro profile, it never did it.

[rasmusdc]

I would start by removing the G28, I know it is only supposed to home the X axis, but I dont think you the "X0". I beleive you only need the "G28 X".

Not sure why you want to re-home just the X Axis you could just do a G0 X0, that will move X to the 0 position without running the home routine.

Just updated firmware, and running Cura, instead of Simplify3d, Cura does the job, and ends the print correctly, so i guess i will be using cura, but i REALLY like simplify3d, so i must se if i can locate the issue, tried different print from Laptop, with the profile that once worked, and nope, still ends up at Z=0 when print is done.