Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 46

Thread: Mpcnc

Hybrid View

  1. 06-07-2019, 07:14 PM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,152
    Add Roberts_Clif on Thingiverse
    Quote Originally Posted by curious aardvark View Post
    can you use grbl for this ?

    So much more user friendly than marlin (what isn't ?)

    Other than that, looking good :-)
    I can choose between Marlin and grbl for Cyclone. I just testing my Controller with Marlin will see about testing grblForCyclone real soon.

    Today I received the five steppers motors, and setup a Ramps controller test, decided to start with a V-Ref of .450. Setup all steppers an preformed simple moves on X, Y, Z, X2 an Y2


    Do you have a simple tutorial of why grbl is better

    Thank You
    Last edited by Roberts_Clif; 06-08-2019 at 11:03 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules