Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 12

Hybrid View

  1. 05-10-2019, 04:34 PM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,152
    Add Roberts_Clif on Thingiverse
    I would increase the infill density to 30% for this object. This is an increase of only 5%
    Reply With Quote Reply With Quote
  2. 05-10-2019, 04:43 PM #2
    Architect401
    Architect401 is offline
    Student
    Join Date
    May 2019
    Posts
    8
    Quote Originally Posted by Roberts_Clif View Post
    I would increase the infill density to 30% for this object. This is an increase of only 5%
    My mistake, I must not have saved the profile as I usually run at 35% for most of my PLA parts.

    I am currently test running PETG to see if I get better results. Any thoughts as to what would cause the material to goop up?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules