So I figured out a way to get things to stick, I have glass with painters tape and polymide tape on that and the nozzle pretty close to the surface going at about 8mm/sec for the first layer and about 15-20 for the rest. Going super slow it's the only way it works. But I have a new question based on print strength. I'm making a radio bracket for my car and on one section where I have to small pillars where a screw would go between they don't print as clean and don't seem to hold as good strength as the rest of the part. I get better results turning the cooling fan almost off on that part but they don't seem to be solid. Infill is 70%. I'll post pictures of what I mean in a little bit