Can anyone help before my printer is thrown out the window

[liqwidsilver]

The surface is a removable magnetic. Not sure the proper term. I did not use the glue yet. That is on my list of things to try.

The printer had an auto level function which when I just did a manual it was way off. So I did correct the level I feel. The company gave me a flimsy scratch paper for leveling.

I do not remove the filament and then heat the nozzle. Bed temps is set to a solid 65c now.

There is an advanced settings option, but really not sure what to adjust to get it correct. I will increase the temp to 200 and see if that helps.

I did just try the same print again and I do have a complete print, but the quality is absolutely terrible and the back end almost looks melted. I have attached the photos of the latest.