Results 1 to 2 of 2
Hybrid View
-
04-23-2019, 05:22 AM #1
I think this is a case of too little, too late.
'please write me a custom firmware for an unknown motherboard, by the way I need it tomorrow.'
The board should have some form of idnetification printed on it - that would be somewhere to start.
Not all anet a8 kits will come with the same boards, the machine has been around for a while and no doubt the manufacturers have found and changed to cheaper parts and suppliers a number of times.
Also you need to power the laser from the extruder connector - NOT the fan connector. gcode for switching the extruder on and off during movement is already incorporated into the firmware.
Fan on and off is usually layer specific.
This is a complicated and long term project. Not something to rattle off in a few hours and expect it to actually work.Last edited by curious aardvark; 04-23-2019 at 05:27 AM.
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials