Creality Ender 3, prints suddenly total mess

[Roberts_Clif]

Hello;

I looked at your Sliced model using idealMaker by Rasie3D Image below.

Image2.jpg

Then I download the Models from Thingiverse an re-sliced saved the model G-Code.
Viewed model using idealMaker by Rasie3D Image below.

Image4.jpg

As you can see your model top was somehow sliced wrong, causing the stringing.
Your sliced model should look more like the model on the bottom that I had sliced.

[DonMathi]

Hello Roberts_Clif,

thank you very much for your input and your time.
it's very weird that it sliced it like that, since i ran the model three times through cura with different settings.
I will try it again with more "conservative" settings and hopefully it comes out the right way.