To add a little more.

Went through and took apart the feeder wheel and cleaned that, took apart the extruder and cleaned that along with the line. Tried loading the amazon stuff back in and it loads fine and as soon as it hits the extruder the feeder starts skipping. Tried slowing the print down, raising the temp with no luck.

I put the sample reel of FlashForges stuff back in and testing it on stock settings/temp on the (Low Setting) which is .30mm height and 80mm/s base speed at 210C temp

The sample stuff was popping some but not nearly as pad as the amazon pla. My guess is this printer and the amazon stuff doesn't get along.

Put the red back in and so far no popping after resetting everything