Results 1 to 10 of 11
Thread: heating issue
Hybrid View
-
04-10-2019, 08:54 AM #1
- Join Date
- Apr 2019
- Posts
- 9
So after some fiddeling I have been able to get the heat bed up to temp but the hot end will only reach 145 degrees and than the system goes in to the E1 error. I have checked all the connections and the wires look good. I checked the resistance on the line and this to looked good. The only other thing I can think of is the thermal runaway protection being set a bit to aggressive. Before I go playing with safety features however I wanted to check if this sounds right. Any help would be great. Thank you.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help