Results 1 to 10 of 14
Thread: Looking for pet-g settings
Threaded View
-
03-27-2019, 11:45 AM #2
What i have so far:
print temp: 240c
bed temp: 80c
those seem to be spot on. Getting good layer adhesion and it's sticking way way better than it was at 65c.
retractions wise currently up to 4mm at 70mm/s.
Just changed from 50mm/s = which is good, but slow. To 60mm/s - still slow, but I want all the speed I can get :-)
Running at 0.32mm layer with first layer at 150% height.
Got first layer speed at 10%, I'll try that at 15% for the next test.
Right think this is good as it's going to get.
15% first layer
65mm/s max speed - tempted to go for 75, but everything I've read reckons 65 is about as good as it gets.
4.5mm retraction at 70mm/s
240 print temp
80c bed temp
fan is on 0% first layer and 50% for all others.
stringing is minimal. Top klayer finish is acceptable.
Adhesion on the printbite looks good. no lifting visible anywhere.
Time to make an actual mould :-)Last edited by curious aardvark; 03-27-2019 at 12:22 PM.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help