Support Touching Buildplate not printing fully

[Roberts_Clif]

The first layer is your most important layer.

I believe you are retracting to far try 4.5mm with a Z-Hop of .075 reduce fan min to 40 and fan max to 60.

https://all3dp.com/2/3d-printing-wit...ow-to-succeed/

[Firepower]

Roberts_Clif

Thanks for the good information. I got most of what you said and I think you mean the 4.5mm in Minimium Travel. I'll check out that link also.

I'll try those settings after the current print I am doing and let you know the difference.

EDIT: With slowing down the speed with PETG and your changes I can get a reasonable first layer which is an improvement on what I was getting.

But before I go any further I will load the latest Cura which will take a while for me to get going I guess.

Thanks