Support Touching Buildplate not printing fully

[Firepower]

Yes. You are correct the Support prints way too fast.

I'll keep looking on the attached photo to see if I can find out how to slow it down.

Can you see any suggestions where I would slow it down on the attached photo. Maybe it is the Infill Speed and there is no separate speed for Supports.

Thanks. Much appreciated for your comment. I may be able to print well almost properly after all these years.


EDIT: I reduced the infill speed but it did not slow down the printing of the Support.

I just lowered Travel Speed and Inner Shell Speed and that did not slow down the Support.

I am using an old Cura. Looks I need to use the new Cura.