Ender 3 print skiping lines, creating gaps

[Madda]

So after filming and looking at the print it turned out like this.
20190316_121630.jpg20190316_121640.jpg
The video isnt short about 2h since i messed up and put another clip into it, as well i used a free version of a softwear so it hade to put a water mark in the center....i hope you can still see the z axil.
https://drive.google.com/file/d/1u8r...ew?usp=sharing
It has a few flaws still but i want to know if the Z axil is good.

[Roberts_Clif]

In the posted Image your model looks good

I use A Raspberry Pi running OctoPrint - with a OctoLapse plugin to get this kind of effect.

PI3 SD Card Holder
https://youtu.be/yDIp0vO5w14

7mm Bed Clamp Small
https://youtu.be/xG2-Bq0qcjw


OctoPrint Controls my 3D Printers and WebCams while the OctoLapse help create a Print lapsed video.

[Madda]

In the posted Image your model looks good

I use A Raspberry Pi running OctoPrint - with a OctoLapse plugin to get this kind of effect.

PI3 SD Card Holder
https://youtu.be/yDIp0vO5w14

7mm Bed Clamp Small
https://youtu.be/xG2-Bq0qcjw


OctoPrint Controls my 3D Printers and WebCams while the OctoLapse help create a Print lapsed video.

I spent 200+$ on equipments today. So i hope to go get great results