3d printing at home setup

[Roberts_Clif]

I have been thinking about moving them to my garage, clearing out a spot and setting up a little 3d workstation.

con: the garage is not as climate controlled as the house. I live in So Cal so the temperatures are not that extreme anyway. And I have a portable heater and a portable a/c unit.

I have Multiple 3D Printers i have them stationed as satellites so to speak.

My 3D Printers a controller by a Raspberry Pi running Octoprint which can be wired or wireless Ethernet.
I control / monitor them from anywhere. using Plugins for Octoprint while viewing the print status via a Web Cam.

Octoprint allows the complete control over the 3DPrinter including an "EMERGENCY STOP BUTTON"

As far as a Garage that does not have the Perfect climate control,
I simply made a Dual 3D Printer Climate Control box from a single Sheet of Partial board Then used Plastics Sheets with hinges for doors.

Including smoke alarm, an Bathroom Fan Vent to exhaust fumes to outside by Dryer exhaust vent.

The Twins 2018-3.jpg