3d printing at home setup

[curious aardvark]

we aim to please :-)

I will add that if you're making models that frequently use a lot of supports - then a dual setup is worth a try as you can use one extruder for soluble supports. Which will make removing supposrt much much easier as you just srop them in asink of warm water.

For role playing models it's ideal. Or for things that just have geometries difficult to print without supports.

A 2 into one nozzle for a delta is a good place to start.
bear in mind that with sufficient cooling some pla will print up to 230-240, so it gives you scope for matching whatever the second filament is.