Results 1 to 8 of 8
Hybrid View
-
03-07-2019, 03:07 PM #1
- Join Date
- May 2018
- Posts
- 566
The Esun PLA+ will leave white dots where a support was.. picking at it with a dental pick can remove it if you have the patients. You can see them on the base of one.. I got tired of scraping..Well you could on the original image.. forum reduced the size I guess..
Last edited by airscapes; 03-07-2019 at 03:15 PM.
-
04-05-2019, 08:18 AM #2
- Join Date
- Dec 2018
- Posts
- 62
I am a big fan of the reheating. It works on ABS too. I have not used a heat gun though, only an open flame. I have had success with a lighter and with a cook's blowtorch.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion