Quote Originally Posted by Yancy View Post
These are very impressive looking. What is the fast you can print with the MOD-t. If these were done at 30mm/s, what is the fasted you can set it to print at?
We've tested printing at up to 100mm/sec and slewing at 200mm/sec, but for the most part, you'll want to limit the print speed to more like 80mm/s (this is the value listed in the specs). How fast you can print depends a lot on the particular part geometry and also on the print quality you are looking for. The stemwinder is a very flexible part, and hence, needed a lower print speed to maintain good quality.