Printing a motorcycle headlight bucket on Raise 3D Pro2

[airscapes]

ABS will work, I made a lamp door for my DLP projector and has not distorted at all.. PLA blew out in an hour.

My new favorite is Taulman Alloy 910.. no heated bed but does print at 250C Really like it a lot, no smell and really tough stuff.
http://taulman3d.com/910-features.html
Prints as good though a .25 nozzle as a .5.
Had issues with thickness consistence .. emailed them and they replaced the roll, but I have not had time to check it. Either way I like this material for thing that need to be robust. Print better than PETG thats for sure.. look at this tiny box and screw adjuster .

.20190118_102702.jpg box small.jpg

[motomucci]

ABS will work, I made a lamp door for my DLP projector and has not distorted at all.. PLA blew out in an hour.

My new favorite is Taulman Alloy 910.. no heated bed but does print at 250C Really like it a lot, no smell and really tough stuff.
http://taulman3d.com/910-features.html
Prints as good though a .25 nozzle as a .5.
Had issues with thickness consistence .. emailed them and they replaced the roll, but I have not had time to check it. Either way I like this material for thing that need to be robust. Print better than PETG thats for sure.. look at this tiny box and screw adjuster .

.20190118_102702.jpg box small.jpg

I was just reading about that alloy filament on MH. It sounds pretty cool. Unfortunately I don't think it will stand up to the heat in this case. It has a "95?C working range" which I assume is the limit for heat deformation.

[airscapes]

I was just reading about that alloy filament on MH. It sounds pretty cool. Unfortunately I don't think it will stand up to the heat in this case. It has a "95?C working range" which I assume is the limit for heat deformation.

I just goggle Tg as I was unaware of the specs meaning.. this article is on the sport for the alloy 910 discussion.
https://shop.prusa3d.com/forum/print...eem-t6661.html