Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 23

Threaded View

  1. 01-29-2019, 08:57 AM #19
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,152
    Add Roberts_Clif on Thingiverse
    It appears that your gear that moves the filament is not aligned, the gear teeth need to bite into the filament.
    The gear could either be reversed or pulled out so the filament centers the teeth.

    And one set screw should be tightened onto the flat surface of the stepper motor shaft Key.
    Last edited by Roberts_Clif; 01-29-2019 at 09:16 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules