Results 1 to 9 of 9
Thread: print moving upward as printed
Hybrid View
-
01-24-2019, 09:07 AM #1
also check your z-steps, might be moving up that extra bit if the steps aren't right.
-
01-25-2019, 09:16 AM #2
- Join Date
- Jan 2019
- Posts
- 8
ok, sorry , completely new to this . I change those setting by the config file right. Any starting suggestions?here is the current on default config:
#Drive current
>CURRENT_VREF_XY 1000 #Default motor current for XY in mA??range (0~1000)
>CURRENT_VREF_Z 1000 #Default motor current for Z in mA??range (0~1000)
>CURRENT_VREF_E 1000 #Default motor current for E in mA??range (0~1000)
-
01-25-2019, 05:26 PM #3
Then I do know have a clue of how to adjust your V-Ref.
We were talking about Layer Shifting and I posted
https://reprap.org/wiki/Shifted_layers
This site has many ideals on layer shifting.,
Could not see your posted thumbnail photo was too small to view.
-
02-11-2019, 10:51 AM #4
- Join Date
- Jan 2019
- Posts
- 8
3d board.jpghere the board pic again.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials