print moving upward as printed

[adam120674]

ok, sorry , completely new to this . I change those setting by the config file right. Any starting suggestions?here is the current on default config:
#Drive current
>CURRENT_VREF_XY 1000 #Default motor current for XY in mA??range (0~1000)
>CURRENT_VREF_Z 1000 #Default motor current for Z in mA??range (0~1000)
>CURRENT_VREF_E 1000 #Default motor current for E in mA??range (0~1000)

[Roberts_Clif]

Then I do know have a clue of how to adjust your V-Ref.
We were talking about Layer Shifting and I posted

https://reprap.org/wiki/Shifted_layers

This site has many ideals on layer shifting.,

Could not see your posted thumbnail photo was too small to view.

[adam120674]

3d board.jpghere the board pic again.