The ender 3 has a heated bed, tends to run at 60C standard, so the adhesive may not be needed for every single print. Looking around I've noticed the Lokbuild beds don't seem to sell at the ender's 235x235 bed sizes, closest seems to be 203x203. Would that be close enough or should I try to buy bigger then trim it down to the proper size? If that doesn't work, is there a way to remove the melted plastic from the bed or should I just offset the nozzle more and clamp a glass plate onto the bed? Longer heat up times I know, but that's fine by me if my prints will stick and be removed cleanly / easily.