Would the new Anet A8 Plus support Nylon filament?

[curious aardvark]

get the right nylon and you shouldn't have abny problems.
Don't buy the cheap stuff - get taulman 645
Works well without a heated print volume and prints at 245c :-)

[airscapes]

Just got a roll of Taulman 910 which seems like really neat stuff! I only printed a few cal squares and did not dry it first (was rather wet) but still printed very well with a .5 nozzle ate 250c with ad 65C bed. The roll I got was rather inconstant as far as roundness and size goes. I had to set the filament thickness to 1.68mm to get proper extrusion. Despite that, the stuff is really strong! My cal square is .6m thich and 3mm tall and I could not break it apart with my fingers.. stretched it, but it would not break! Can't wait to try it on a mechanical part!