PLEASE! I need help with my Ender 3.

[Madda]

-I put something behind the spring tightening it.
-Then i raised the bed a bit after watching this guys first layer that resembeld mine https://www.youtube.com/watch?v=AaF28dnDgKA (Need to raise it just a bit more) and
tried "Hictop Blue - .20.curaprofile" that i got from you.
-It stuck onto the bed the entire print so it finished. But i could hear the nozzle going through and breaking some of the infill when it crossed.
20190210_094926.jpg20190210_094941.jpg20190210_094956.jpg20190210_095032.jpg
It's a massive improvement compared to the others. But it's not flat and is rough wrinkles on the side.
The entire boat is very roughly made if that makes sense.
Is it under extrution?

[Roberts_Clif]

What are you using for Nozzle and Bed temperature.
What print speed percent is Cura set to.

What you are telling me is that you may have too low nozzle temp or the popping sound could be moisture in the filament.

[Madda]

What are you using for Nozzle and Bed temperature.

Default printing temp 205C
printing temp 198C
printing temp Initial layer 198C
Initial printing temp 188C
Final printing temp 183C
Default build printing temp 70C
build printing temp 50C
build printing temp Initial layer 50C

What print speed percent is Cura set to.

(I cant find it, but i found these)
Print speed 60mm/s
Initial layer print speed 10mm/s
Overhanging wall speed 100%

The popping sound could be moisture in the filament

Shit...Do i have to replace it?

[Roberts_Clif]

Shit...Do i have to replace it?

I do not know was only making a statement, Have you tried to print a temperature tower.

Do not like the one I selected More here

Your temperature settings look to be the same as what is being used in my 3DP11/12 though all 3D Printers do not Print using the exact same temperatures.

[Madda]

I do not know was only making a statement, Have you tried to print a temperature tower

I printed the tower but it didn't finish.
20190212_180304.jpg20190212_180320.jpg20190212_181255.jpg
Thefirst layer looks great now.

[Roberts_Clif]

It is OK.
That it did not finish you got good results you may want to search and print a new tower with higher printer temps.

[Madda]

It is OK.
That it did not finish you got good results you may want to search and print a new tower with higher printer temps.

Well here it is, looks like 205C and higher gave good results.

20190213_194719.jpg20190213_194851.jpg