I set it at 10 and it seemed like it got further before the plastic had enough of the nozzles work and wanted to leave the bed (I suspect that the plastic keept rising and started getting contact with the nozzle).

When printing it seems like it makes a small line and then hurls the rest into a hill and start all over from there.
[Like this __o__o__o__o__o__o]
I have no ide why. Do i need to increase the flow? Is the fan cooling it too fast?
Flow 100.
Fan speed 100%. Regular/Maximum fan speed threshold 10s.

Also goo buts that new. (Haven't goten this far)

20181224_075339.jpg20181224_075404.jpg20181224_075441.jpg