Results 1 to 10 of 41
Threaded View
-
01-26-2019, 10:39 PM #14
- Join Date
- Dec 2018
- Location
- Sweden
- Posts
- 22
I don't know how to import your profiles into cura yet.
So i used the profile that i hope got attached to this post. Cura profile.zip
Here are the results before it let go of he bed (Is it becuase the gaps?).
20190127_051246.jpg20190127_051257.jpg20190127_051415.jpg20190127_051457.jpg
I can see gaps on the print and the first layer did not become a "Solid" layer (I can see each thread).
I think the gaps are visible in the second pic where the light comes through.
It's not the full print but it got further then last time
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion