-I put something behind the spring tightening it.
-Then i raised the bed a bit after watching this guys first layer that resembeld mine https://www.youtube.com/watch?v=AaF28dnDgKA (Need to raise it just a bit more) and
tried "Hictop Blue - .20.curaprofile" that i got from you.
-It stuck onto the bed the entire print so it finished. But i could hear the nozzle going through and breaking some of the infill when it crossed.
20190210_094926.jpg20190210_094941.jpg20190210_094956.jpg20190210_095032.jpg
It's a massive improvement compared to the others. But it's not flat and is rough wrinkles on the side.
The entire boat is very roughly made if that makes sense.
Is it under extrution?